The Hub

I did some testing of peel strength for ABS plastic/unfinished wood bonds using various glues. I found some interesting results and am continuing to test with additional glues and an improved method. TL;DR: Non-aqueous glues as a class outperformed the aqueous glues Testors 3505 and thin cyanoacrylate provided the strongest non-aqueous glue bonds Among the nontoxic water cleanup glues, Canopy 560 glue exhibited a significantly higher mean p…

Hi, I just saw the Trussrod repair/ new fretboard post by Dan Erlewine and Rodrigo Gomes. I really liked it, especially the idea of carving the fretboard with the table saw! I could not comment on the article. I am sure there was a reason for replacing the whole fingerboard in their case. I wanted to document an alternative method that I tried two weeks ago with sucess. I did not invent it though, i have seen it somewhere in the interne…

Lyon and Healy Parlor repair. Is there any good method to soften/release old hide glue and re-clamp to close the gap? The braces will be removed and new X bracing installed. This appears to be a very old repair using hide glue, but it wasn't quite closed up at the time of the original repair so the crack is still open. Its holding very well and we may just leave it. But wanted to run this by the group. Looking to perhaps steam it along t…

Hey guys, I’d love to get some suggestions on how to finish this repair aesthetically. The customer brought it in because this piece had split while trying to remove the saddle using a rubber mallet. My main concern is that the joint between the two pieces of wood is still visible. I was thinking of doing what I’ve always done: using wood dust mixed with CA glue or Titebond. But I was wondering if you guys use a different method that migh…